Checking Drive Belts; Checking And Replacing Fuses; Replacing A Fusible Link; Replacing Accessory Fuse - Hyundai 2003 Sonata Owner's Manual

6- 18
DO-IT-YOURSELF MAINTENANCE
G190A01A-AAT

CHECKING DRIVE BELTS

V6
Power Auto
Eng.coolant
steering tensioner
0.30~0.48in. 0.24~0.35in.
Generator
Generator
COMP
Eng.pulley Eng.pulley
Drive belts should be checked periodically for
proper tension and adjusted if necessary. At the
same time, belts should be examined for cracks,
wear, fraying or other evidence of deterioration
and replaced if necessary.
Belt routing should also be checked to be sure
there is no interference between the belts and
other parts of the engine. After a belt is replaced,
the new belt should be adjusted again after two
or three weeks to eliminate slack resulting from
initial stretching after use.
G200A01Y-GAT
CHECKING AND REPLACING
FUSES
DOHC

Replacing a Fusible Link

Power
steering
COMP
HSM396
A fusible link will melt if the electrical circuits from
the battery are ever overloaded, thus prevent-
ing damage to the entire wiring harness. (This
could be caused by a short in the system
drawing too much current.) If this ever happens,
have a Hyundai dealer determine the cause,
repair the system and replace the fusible link.
The fusible links are located in a under hood
junction box for easy inspection.
!
When replacing a fusible link, never use
anything but a new fusible link with the
same or lower amperage rating. Never use
a piece of wire or a higher-rated fusible link.
This could result in serious damage and
create a fire hazard.
Bad
Good
G200B01Y-GAT

Replacing Accessory Fuse

G200A01L
The instrument panel junction box for the lights
and other electrical accessories will be found
low on the dashboard on the driver's side. Inside
the box you will find a list showing the circuits
protected by each fuse.
CAUTION:
G200B01Y