Yamaha 2001 YZF-R6N Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
3
1. Oil level symbol " "
2. Oil level/coolant temperature
warning light " "
3. Coolant temperature symbol "
Oil level/coolant temperature
warning light " "
This warning light has the following
three functions.
When the engine oil level is low,
the warning light comes on and
symbol " " flashes. If this oc-
curs, stop the engine immediately
and add engine oil to the specified
level.
When the coolant temperature is
too high, the warning light comes
on and symbol "
the motorcycle and allow it to idle
until the coolant temperature goes
down. If the temperature does not
go down, stop the engine. (See the
"Engine overheating" section on
page 6-48 for further instructions.)
When the engine oil level is low
and the coolant temperature is too
"
high, the warning light flashes and
symbols "
EAU03723*
To check that the warning light is work-
ing properly:
Put the transmission in neutral or
apply the clutch lever.
Turn the engine stop switch to
" " and the key to "ON".
The warning light will come on and
symbols "
pear in the display.
If the warning light does not come on,
have a Yamaha dealer inspect the
" flashes. Stop electrical circuit.
CAUTION:
_
_
NOTE:
_
Even if the oil is filled to the specified
" and " " come on.
level, the warning light may flicker
when riding on a slope or during sud-
den acceleration or deceleration, but
this is normal.
_
" and " " will ap-
3-3
Do not operate the motorcycle
until you know that the engine
oil level is sufficient.
Do not operate the engine if it is
overheated.
EC000118