Yamaha 2001 YZ426F/LC Owner's Service Manual page 136

1 Clamp
2 Ignition coil
3 High tension cord
4 CDI unit
5 CDI unit band
6 Throttle cable (pull)
7 Throttle cable (return)
8 Radiator (left)
9 Radiator breather hose
0 Radiator (right)
A CDI unit stay (frame)
CABLE ROUTING DIAGRAM
Å Fasten the ignition coil lead to the
frame with a plastic band.
ı Fasten the ignition coil and ground
lead to the frame with the bolt.
Ç Pass the ignition coil lead (in the
sub wire harness) so that it does
not contact the carburetor and
rear shock absorber and connect
it with the lead from the ignition
coil on the inside of the frame.
Î Pass the throttle cables over the
high tension cord.
‰ Pass the throttle cables along the
outer side of the CDI unit leads.
Ï Using a plastic locking tie, clamp
to the frame the CDI unit leads at
their protecting tubes.
2 - 24
SPEC
Ì Pass the throttle cables between
the top radiator mounting boss
and middle radiator mounting
boss.
Ó Pass the CDI unit leads over the
top radiator mounting boss.
È Cross the pull and return throttle
cables before the radiator.
Ô Pass the throttle cables through
the cable guide.
Pass the radiator breather hose
between the frame and the radia-
tor without pinching it.
Ò Pass the radiator breather hose
behind the decompression cable.
˜ Insert the CDI unit band over the
CDI unit stay (frame) as far as
possible.