Toyota 2003 Prius Owner's Manual page 179

Ignition switch with steering
lock51.
25p001c
"START"—The hybrid system is ready
to operate.
Turn the key to the "START" position and
hold the ignition switch at this position for
about a few seconds until the "READY"
light comes on and a beep sounds. (If the
ambient temperature is low such as during
winter conditions, it may take time until
the "READY" light is on." The key will
return to the "ON" position when released.
Being different from ordinary vehicles, you
cannot start your vehicle with the running
mode selector lever in "N" position.
"ON"—The hybrid system starts to run
when the accelerator pedal is depressed
with the "READY" light and all accesso-
ries on.
104
This is the normal driving position.
"ACC"—Accessories such as the radio
operate, but the hybrid system is off.
If you leave your key in the "ACC" posi-
tion for a while, put the running mode
selector lever in "P" position.
If you leave the key in the "ACC" or
"LOCK" position and open the driver's
door, a buzzer will remind you to remove
the key.
"LOCK"—The hybrid system is off and
the steering wheel is locked. The key
can be removed only at this position.
You must push in the key to turn it from
"ACC" to the "LOCK" position. The selec-
tor lever must be put in the "P" position
before pushing the key.
Vehicles with hybrid vehicle immobiliser
system–Once you remove the key, the hy-
brid vehicle immobiliser system is auto-
matically set. (See "Hybrid vehicle immobi-
liser system" on page 20 in Section 2–1.)
When starting the hybrid system, the key
may seem stuck at the "LOCK" position.
To free it, first be sure the key is pushed
all the way in, and then rock the steering
wheel slightly while turning the key gently.
NOTICE
Do not leave the key in the "ACC" or
"ON" position for a long time when
the hybrid system is off. The auxiliary
battery will discharge.