Table of Contents
Advertisement
HomeLink Universal Transceiver
Erasing Codes
To erase the codes stored in all three
buttons, press and hold the two
outside buttons until the red light
begins to flash, then release the
buttons.
You should erase all three codes
before selling the vehicle.
Retraining a Button
If you want to retrain a programmed
button for a new device, you do
not have to erase all button memory.
You can replace the existing memory
code for that button using this
procedure:
1. Press and hold the HomeLink
button to be trained until the
HomeLink indicator begins to
flash slowly.
If a rolling code transmitter
was previously programmed,
the indicator will flash rapidly
for 2 seconds, then stay on
for about 23 seconds.
158
If a standard transmitter was
previously programmed, the
indicator will stay on for about
25 seconds.
2. Once the HomeLink indicator
begins to flash slowly, continue
to hold the HomeLink button,
and follow steps 3 thru 6 under
''Training HomeLink'' (see
page 155).
Customer Assistance
If you have problems with training
the HomeLink Wireless Control
System, or would like information on
home products that can be operated
by HomeLink, call (800) 355-3515.
On the Internet, go to www.
homelink.com.
HomeLink is a registered
trademark of Johnson Controls, Inc.
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
Advertisement
Table of Contents
