Table of Contents
Advertisement
Training HomeLink
Before you begin
− If you just
received your vehicle and have not
trained any of the buttons in
HomeLink before, you should erase
any previously learned codes before
training the first button. To do this,
press and hold the two outside
buttons on the HomeLink
Transceiver for about 20 seconds, or
until the red light flashes. Release
the buttons, then go to step 1.
If you are training the second or
third buttons, go directly to Step 1.
1. Unplug the garage door opener
motor from the electrical outlet.
2.
Hold the end of the garage door
opener remote 2 to 5 inches from
HomeLink. Make sure you are not
blocking your view of the red
indicator in HomeLink.
3. Press and hold the remote trans-
mitter button and one of the
HomeLink buttons at the same
time.
If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
buttons, and go to step 5.
If the red indicator in HomeLink
continues to flash slowly (does
not flash rapidly), it may be
because your remote transmitter
stops transmitting after a short
time. Go to step 4.
HomeLink Universal Transceiver
CONTINUED
155
Advertisement
Table of Contents
