Toyota 2007 Camry Hybrid Owner's Manual page 315

JUMP STARTING PROCEDURE
1. If the booster battery is installed in
another vehicle, make sure the vehicles
are not touching. Turn off all unneces-
sary lights and accessories.
When boosting, use the battery of
matching or higher quality. Any other
battery may be difficult to jump start
with.
If jump starting is difficult, charge the
battery for several minutes.
2. If required, remove all the vent plugs
from the booster battery. Lay a cloth
over the open vents on the battery.
(This helps reduce the explosion haz-
ard, personal injuries and burns.)
3. If the engine in the vehicle with the
booster battery is not running, start it
and let it run for a few minutes. During
jump starting, run the engine at about
2000 rpm with the accelerator pedal
lightly depressed.
'07Camry hybrid_U (L/O 0610)
Discharged battery
Booster
battery
Positive
terminal
("+" mark)
Positive terminal
Jumper cable
("+"mark)
4. Make the cable connections in the or-
der a, b, c, d.
a. Connect the clamp of the positive
(red) jumper cable to the positive (+)
terminal of the discharged 12 volt bat-
tery.
b. Connect the clamp at the other end
of the positive (red) jumper cable to
the positive (+) terminal of the booster
battery.
Jumper cable
Discharged battery
Negative terminal ("−"mark)
c. Connect the clamp of the negative
(black) jumper cable to the negative (−)
terminal on the booster battery.
d. Connect the clamp at the other end
of the negative (black) jumper cable to
a solid, stationary, unpainted, metallic
point of the vehicle with the discharged
battery.
2007 CAMRY HV from Oct. '06 Prod. (OM33749U)
Booster
battery
315