Toyota 2007 Camry Hybrid Owner's Manual page 174

TIRE PRESSURE WARNING
SWITCH
When initializing the system, the present
tire inflation pressure is stored as stan-
dard. The tire pressure warning system
determines decreased air pressure
comparing the present and the standard
tire inflation pressures. When you change
the set tire inflation pressure, it is neces-
sary to initialize the tire pressure warning
system.
D
When rotating the tires on vehicles dif-
fering with front and rear tire inflation
pressures.
174
D
When changing the tire size.
To initialize the system, perform the fol-
lowing:
1. Park the vehicle in a safe place and
turn the "POWER" switch off.
2. Adjust the pressure of all the installed
tires to the specified cold tire inflation
pressure level. (See "Tires" on page
385 in Section 8.)
3. Press the "POWER" switch and set it
at ON.
4. Open the glove box, and push and hold
the tire pressure warning reset switch
RESET
until the tire pressure warning light
blinks slowly three times.
5. Leave the system for a few minutes
with the "POWER" switch set at ON
and then turn the "POWER" switch off.
by
If you push the tire pressure reset switch
while vehicle is moving, initialization is not
performed.
If you push the tire pressure reset switch
accidentally and initialization is performed,
adjust the tire inflation pressure to the
specified level and initialize the system
again.
'07Camry hybrid_U (L/O 0610)
If the tire pressure warning light does not
blink slowly three times when you push
and hold the reset switch, initialization has
failed and the tire pressure warning sys-
tem may not work properly. In this case,
initialize the system again. If initialization
cannot be performed, have the system
checked at your Toyota dealer.
2007 CAMRY HV from Oct. '06 Prod. (OM33749U)