Ingenico 5100 Operating Manual page 20

SKYZER TECHNOLOGIES
7. At the conclusion of the synchronisation process, the i3010 pinpad will
display:
8. The i5100 terminal will now automatically reboot itself to establish
connection with the i3010 pinpad.
9. The i3010 pinpad will now display "PAYMARK EFTPOS" which is its
standard idle screen.
In the unlikely event that the i3010 pinpad has not been synchronised with the
serial number, perform the steps below to complete the installation process:
10. The i5100 terminal will prompt for the serial number of the i3010 pinpad to
be entered. Key the 10 digit serial number (found on the back of the
i3010 pinpad) into the i5100 terminal and press ENTER.
11. The i5100 terminal will prompt to re-enter the serial number and press
ENTER.
NOTE: When replacing an i3010 pinpad, ensure that the power supply to the
i5100 terminal is turned off. Unplug the i3010 pinpad cable from the RS232-1
port on the i5100 terminal and then proceed from step 2(as above).
INGENICO 5100 PAYMARK VERSION 6.0 OPERATING GUIDE
I3010 I3010 I3010 I3010 PCI PCI PCI PCI 02.0X 02.0X 02.0X 02.0X
1234- - - - D D D D 1234 1234 1234
PAYMARK PAYMARK PAYMARK PAYMARK
EFTPOS EFTPOS
EFTPOS EFTPOS
Enter Serial Num Enter Serial Num
Enter Serial Num Enter Serial Num
Re Re- - - - enter Serial Re Re enter Serial enter Serial enter Serial
PAGE 20 OF 97
Version 1.3