Viewing The Current Instrumentation Monitor Configuration; Configuring Radius Server Support For Switch Services; Introduction - HP 2530 Manual Supplement

HP Switch(config)# instrumentation monitor learn-discards
To disable monitoring of learn discards:
HP Switch(config)# no instrumentation monitor learn-discards
To enable or disable SNMP trap generation:
HP Switch(config)# [no] instrumentation monitor trap

Viewing the current instrumentation monitor configuration

The show instrumentation monitor configuration command displays configured
thresholds for monitored parameters.
Example 19 Viewing the instrumentation monitor configuration
HP Switch# show instrumentation monitor configuration
PARAMETER
------------------------- ---------------
mac-address-count
ip-address-count
system-resource-usage
system-delay
mac-moves/min
learn-discards/min
ip-port-scans/min
arp-requests/min
login-failures/min
port-auth-failures/min
SNMP trap generation for alerts: enabled
Instrumentation monitoring log : enabled
You can also view the current instrumentation monitor configuration with the show run command,
which does not display threshold values for each limit set.

Configuring RADIUS server support for switch services

Fix or Feature update?
Feature update: Configuring
RADIUS Server Support for
Switch Services
NOTE: RADIUS ACLs are not supported on the following HP switches: J9779A, J9780A, J9782A,
and J9783A.

Introduction

This chapter provides information on configuring CoS (802.1p priority), rate-limiting, and ACL
client services on a RADIUS server. For information on configuring client authentication capability,
see Chapter 5, "RADIUS Authentication, Authorization and Accounting" in the HP Switch Software
Access Security Guide for your switch.
LIMIT
1000 (med)
1000 (med)
50 (med)
5 (high)
100 (med)
100 (med)
10 (med)
100 (low)
10 (med)
10 (med)
Software Release
Available for software
release YA.15.13 and later.
Affected Chapter/Section
Updated content for Chapter 6 — 'Configuring RADIUS
Server Support for Switch Services' of the HP Switch
Software Access Security Guide
Configuring RADIUS server support for switch services 29