Yamaha RX-V1800 Owner's Manual page 117

Setting remote control TUNER ID
Set the operation mode selector to C AMP or
1
C SOURCE and then press 1 TUNER on the
remote control to select the tuner to change
the remote control ID.
Press and hold L LEARN for about 3
2
seconds using a ballpoint pen or similar
object until "L;TUN" and "TUNER"
alternately appear in the display window (A).
LEARN
3 seconds
Notes
• Be sure to press and hold L LEARN for at least 3
seconds, otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 2.
Press 3 ENTER.
3
The four-digit code set for the selected input area
appears in the display window (A) on the remote
control.
4
Press the numeric buttons ( 5 ) to enter the
four-digit remote control code for the input
area you want to use.
Remote
control
Function
TUNER ID
*1
code
2602 Operates this unit using the
(initial setting) default code.
Operates this unit using an
2603
alternative code.
*1 The remote control setting.
*2 The setting of this unit.
Press 3 ENTER to set the number.
5
"OK" appears in the display window (A) if the
setting was successful.
"NG" appears in the display window (A) if the
setting was unsuccessful. In this case, start over from
step 2.
Press L LEARN again to exit from the setup
6
mode.
LEARN
Advanced setup
RC TUNER
*2
ID
ID1
(initial setting)
ID2
115
En