Privacy Mask - Honeywell HICC-P-3100IRV User Manual

Network Camera User's Guide
Local video output:
Enable or disable video signal of BNC connector. It's very useful to check view angle or
focus during camera installation. However, disable this function will save power a lot.
Suggest to disabling it after camera installed well.
ICR:
Use built-in photo sensor or manual to control ICR.
In case user selects manual mode, there are 4 modes: Night (On), Day (Off), Auto or
Schedule to control built-in IR LEDs. This function is very useful under low illumination
environment even 0 Lux.
In case the Auto mode is selected, user needs to specify 3 parameters in advance:
Night Mode Threshold (0~10000): this value set the threshold to turn on IR LED. It
should be lower or equal to Day Mode Threshold.
Day Mode Threshold (0~10000): this value set the threshold to turn off IR LED. It should
be higher or equal to Night Mode Threshold.
Delay Time: The delay time between LED ON/OFF switching.
Note that Current Value is the current luminance from the captured video. It's a useful
reference to set LED ON/OFF Threshold.
3D De-Noise:
This function can remove or lower unwanted noise and preserve fine details and edges
as possible.
WDR:
This function is to provide clear images even under back light circumstances. The higher
"Strength" level will adjust contrast compensation stronger.
Default Settings:
Restore to factory image settings.

Privacy Mask

Use this page to specify privacy mask window 1 to window 8 and set the name and gray
level for selected window.
Add and Delete:
To add or delete the privacy mask windows, user can specify up to 7 windows to mask
the video captured by this device. By dragging mouse on the image, you can change the
position and size of the selected window accordingly.
Name:
Name of the specified privacy window.
Level
42/89