Using The Infinity With 2 Deluxe Temperature Controllers - Rinnai infinity 32 Operation Manual

OPERATION WITH DELUXE TEMPERATURE CONTROLLERS

Using the Infinity with 2 Deluxe Temperature Controllers

When 2 Temperature Controllers are used, they must be
models MC-70-1A (Kitchen) and BC-70-1A (Bathroom).
Switching the System ON
The hot water system and both controllers can be
switched on and off from either controllers by
pressing the ÔON/OF FÕ button as shown. When the
system is turned on, the monitor will be lit. During
normal operation the system is left on.
Setting the Clock
The clock is of the 12 hour AM/PM type and is set on the
Kitchen Controller (MC-70-1A).
Press the Ô ClockÕ button. The digital monitor
will flash AM 12:00.
Set the time using the Ô HourÕ and Ô Min.Õ
buttons. The time is displayed on the monitor
as the buttons are pressed. The numbers on the
monitor will continuously change if you keep
the buttons depressed. When you get close to
the desired time, press the button
intermittently.
Press the ÔC lockÕ but ton again to activate the
clock.
The time displayed on the Kitchen Controller is automatically displayed on all Bathroom
Controller(s) when the Bathroom Controller(s) are ON. If the controllers are OFF, the time is
only displayed on the Kitchen Controller. The clock may need to be reset after a power failure.
NOTE
C
AM
Transfer
0 0 0 0 Hot water
temp.
Clock Hour Min.
Sound Cooler Hotter
ON/OFF
Vol.
MC -70 -1A
C
AM
Transfer
0 0 0 0 Hot water
temp.
Clock Hour Min.
Cooler Hotter
Sound
ON/OFF
Vol.
MC -70 -1A
ON/OFF
- 21 -
Bath temp.
ON/OFF
C
Water Vol.
Bath Fill
Transfer
C
Sound
Vol.
Hot water temp.
BC - 70 - 1A
Bath temp.
ON/OFF
C
Water Vol.
Bath Fill Transfer
C
Sound
Vol.
Hot water temp.
BC - 70 - 1A
C
AM
0 0 0 0
Clock Hour Min.
Sound
Vol.
C
AM
0 0 0 0
Clock Hour Min.
Sound
ON/OFF
Vol.
C
AM
0 0 0 0
Clock Hour Min.
Sound
ON/OFF
Vol.