Integra DHC-80.6 Advanced Manual page 30

Setting Item Default Value Setting Details
Height 2 Right 9.0ft/2.70m Specify the distance between each speaker and the
listening position.
Height 2 Left 9.0ft/2.70m Specify the distance between each speaker and the
listening position.
r When the speaker is set to "None" in "Speaker Configuration", the settings for "Speaker Distance"
cannot be changed.
r Default values vary depending on the regions.
30
r This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Height 2 Speakers
Type" is set to "Not Use".
– "Speaker Settings" - "Front Speakers Type" is
set to "Bi-Amp".
r This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Height 2 Speakers
Type" is set to "Not Use".
– "Speaker Settings" - "Front Speakers Type" is
set to "Bi-Amp".
Level Calibration
Adjust the level of each speaker with the built-in test tone. Settings are automatically
configured if you use the Automatic Speaker Setup.
Setting Item Default Value
Front Left 0.0dB
Wide Left 0.0dB
Center 0.0dB
Wide Right 0.0dB
Front Right 0.0dB
Surround Right 0.0dB
Advanced Settings
Setting Details
Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.
Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.
r The setting cannot be changed if "Speaker
Settings" - "Front Speakers Type" is set to "Bi-
Amp ".
Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.
Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.
r The setting cannot be changed if "Speaker
Settings" - "Front Speakers Type" is set to "Bi-
Amp".
Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.
Select a value between "-12.0dB" to "+12.0dB" (in
0.5dB increments). A test tone will be output each
time you change the value. Select the desired
level.