Stihl MS 192 Instruction Manual page 27

Hold the saw firmly on the ground
N
with your left hand on the front
handle – your thumb should be
under the handle.
Put your right foot into the rear
N
handle and press down.
Alternative method of starting:
Hold the rear handle tightly between
N
your legs, just above the knees.
Hold the front handle firmly with
N
your left hand – your thumb should
be under the handle.
Pull the starter grip slowly and
N
steadily with your right hand and
push down the front handle at the
same time. Do not pull out the
starter rope all the way – it might
otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
MS 192 C
When the engine begins to fire.
4
If the engine is cold:
Set the choke lever (4) to j and
N
continue cranking until the engine
runs.
If the engine is warm
Continue cranking until the engine
N
runs.
As soon as the engine runs
3
2
Blip the throttle trigger (2) the
N
Master Control lever (3) moves to
the run position F and the engine
settles down to idling speed.
NOTICE
As the chain brake is still engaged, the
engine must be returned to idling speed
immediately or the engine housing and
chain brake might otherwise be
damaged.
Pull the hand guard back toward the
N
handlebar. The chain brake is now
disengaged – your saw is ready for
operation.
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the powerhead and
chain drive (clutch, chain brake).
Always check operation of chain
N
lubrication before starting work.
At very low outside temperatures
Allow engine to warm up at part
N
throttle.
Shut odd the engine.
Move the Master Control lever to 0
N
or STOP.
English
25