Starting / Stopping The Engine - Stihl MS 192 Instruction Manual

English
Starting / Stopping the
Engine
Starting the engine
Observe safety precautions.
The ErgoStart stores the energy
required to start the saw. For this reason
there may be a delay of a few seconds
between cranking the engine and it
actually starting.
Press the fuel pump bulb at least
N
five times – even if the bulb is filled
with fuel.
Push the hand guard forward – the
N
chain is locked.
24
3
2
Press down the throttle interlock (1)
N
and squeeze the throttle trigger (2)
at the same time – hold both levers
in that position.
Move the Master Control lever (3) to
N
n and hold it there.
Now release the throttle trigger,
N
Master Control and trigger interlock
in that order. This is the starting
throttle position.
If the engine is cold
4
Move the choke lever (4) to l.
N
If the engine is warm
1
Set the choke lever (4) to j . Also
N
use this position if the engine has
been running but is still cold.
Place your saw on the ground.
N
Make sure you have a firm footing –
check that the chain is not touching
any object or the ground.
WARNING
Bystanders must be well clear of the
general work area of the saw.
4
MS 192 C