LG DLEY1701VE Owner's Manual page 50

50 TROUBLESHOOTING
Before Calling for Service (conf.)
Problem
Clothes are
wrinkled
Drying time is
not consistent
Clothes take
too long to dry
Clothes are
shrinking
Possible Causes
• Clothes dried too long
(overdried).
• Clothes left in dryer too long
after cycle ends
• Heat settings, load size, or
dampness of clothing is not
consistent.
• Load is not properly sorted.
• Large load of heavy fabrics.
• Dryer controls are not set
properly.
• Lint filter needs to be cleaned.
• Exhaust ducts blocked, dirty, or
duct run is too long
• House fuse is blown, circuit
breaker has tripped, or power
outage has occurred
• Dryer is overloaded.
• Dryer is underloaded.
• Garment care instructions are
not being followed
Solutio.5
• Overdrying a load of laundry can lead to wrinkled clothes
Try a shorter drying time, and remove items while they
still retain a slight amount of moisture.
• Remove items from the dryer immediately at the end
of the cycle Use theWrinkle Care option to continue
tumbling clothes at the end of the cycle, for up to 3 hours.
• The drying time for a load will vary depending on the heat
setting, the type of heat used (electric, natural gas, or LP
gas), the size of the load, the type of fabrics, the wetness
of the clothes, and the condition of the exhaust ducts and
lint filter
• Separate heavy items from lightweight items Larger and
heavier items take longer to dry
• Heavy fabrics take longer to dry because they tend to
retain more moisture.To help reduce and maintain more
consistent drying times for large and heavy fabrics,
separate these items into smaller loads of a consistent
size.
• Use the appropriate control settings for the type of load
you are drying
• Make sure the lint filter is cleaned before every load With
some loads that produce high amounts of lint, it may be
necessary to clean the filter during the cycle
• Confirm that the exhaust ductwork is properly configured
and free of debris, lint, and obstructions. Make sure that
outside wall dampers can open properly and are not
blocked, jammed, or damaged.
• Reset circuit breaker or replace fuse Do not increase
fuse capacity. If the problem is a circuit overload, have it
corrected by a qualified electrician
• Divide larger loads into smaller loads for drying.
• If you are drying a very small load, add a few extra items
to ensure proper tumbling action.
• To avoid shrinkage, please carefully follow the fabric
care instructions for your garment, because some fabrics
will naturally shrink when washed. Other fabrics can be
washed but will shrink when dried in a dryer. Use a low or
no heat setting.
Clean Filter • Lint filter is almost clogged or • Pause the drying cycle and clean the lint filter.
light is on full.
during the
drying cycle
Garments still . Too many or too different types • Small loads of 1 to 5 items work best.
wrinkled after of garments in dryer • Load fewer garments Load similar-type garments.
Steam Fresh
TM