LG DLEY1701VE Owner's Manual page 31

INSTALLAiTION INSTRUCTIONS 31
Connecting Electric Dryers (conf.)
USA only
J_WARNING
• Connect the power cord to the terminal block.
Connect each power cord wire to the terminal block
screw that has the same colored wire. For example,
connect the black power cord wire to the terminal
block screw with the black wire. Failure to follow
these instructions may result in a short, overload,
fire or death.
• Grounding through the neutral conductor is
prohibited for: (1) new branch-circuit installations,
(2) mobile homes, (3) recreational vehicles, and
(4) areas where local codes prohibit grounding
through the neutral conductor.
Three-wire connection for electric dryers: Direct wire
• A 3-wire connection is NOT permitted on new
construction after January 1, 1996,
• A UL-listed strain relief is required.
1, Remove 32j4 inches (8,9 cm) of the outer covering from
the wire. Strip 1 inch (2,5 cm) insulation from each
wire, Bend the ends of the three wires into a hook
shape,
1" (2,5 cm)
F-q
. Use UL-listed :}-wire #10 AWG-minimum copper
conductor cable.
. Allow at least 5 ft. (1.5 m) length to allow for removal
and reinstallation of the dryer.
3. Attach the two hot leads of the power cord to the
outer terminal block screws. Attach the neutral wire to
the center terminal block screw. Connect the external
ground (if required by local codes) to the green
ground screw. TIGHTEN ALL SCREWS SECURELY.
Reinstall the terminal block access cover.
Neutral
Hot
(White)
(Black) [
Ground F_[_ Not
Screw __i_=_o_(Red)
White Wir_
fromDryer" _ "N,:_--_
harness /
External Ground \ \
Wire (If required
by local codes)
2, Remove the terminal block access cover on the upper
back of the dryer. Install a UL-listed strain relief into
the power cord through-hole; then thread the power
cable prepared in 5tep 1 through the strain relief.
Block
aLi_t;dlef
UL-Listed 3-Wire /
Power Cord