Oki IP-7700-26 Quick Reference Manual page 38

Sheet mount cleaning
Check the cleanliness of the print heads nozzle surfaces. If dirty,
clean them using sheet mount cleaning.
You will be prompted to perform cleaning after one month or 0.6
km of print length.
Note
- Do not wipe the print heads nozzle surfaces with a
cleaning swab as it may cause print head malfunction.
„ Preparation when using a head cleaning set for the first
time
Install the two screws supplied with the head cleaning set to
the Printer. (Two more spare screws are also supplied.)
- The screws need to be installed only once. (There is no
need to remove them afterward.)
„ Prepare the sheet cleaning part
Head cleaning part components
Cleaning sheet mount x1
Support sheet x1
1
2
3
Head cleaning sheet x1
Attach the support sheet
ⓐ
ⓑ
ⓒ
ⓓ
Hook two holes of the support sheet to the cleaning
sheet mount attachment locations (a) and (b). Keep the
sheet stretched and hook the two remaining holes to
the attachment locations (c) and (d).
Attach the head cleaning sheet
ⓐ
ⓑ
ⓒ
ⓓ
Place the head cleaning sheet on top of the support
sheet. Hook two holes to the attachment locations
(a) and (b) and then the two others holes to the
attachment locations (c) and (d).
Remove all wrinkles on the head cleaning sheet by
lightly pulling both sides of the sheet top edge in the
direction of the arrows. This will prevent the sheet from
rising near the bottom edge attachment locations.
37