Cleaning The Glass Cooktop; Normal Daily Use Cleaning; Burned-On Residue; Heavy, Burned-On Residue - GE JB750 Instruction Manual

Cleaning the Glass Cooktop
Normal Daily Use Cleaning
ONLY use CERAMA BRYTE ® Ceramic Cooktop Cleaner
on the glass cooktop. Other creams may not be as
effective.
To maintain and protect the surface of your glass
cooktop, follow these steps:
1. Before using the cooktop for the first time, clean it
with CERAMA BRYTE ® Ceramic Cooktop Cleaner.
This helps protect the top and makes cleanup easier.
2. Daily use of CERAMA BRYTE ® Ceramic Cooktop
Cleaner will help keep the cooktop looking new.
3. Shake the cleaning cream well. Apply a few drops of
CERAMA BRYTE ® Ceramic Cooktop Cleaner directly
to the cooktop.
4. Use a paper towel or
CERAMA BRYTE ® Cleaning
Pad for Ceramic Cooktops
to clean the entire cooktop
surface.
5. Use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that
you DO NOT heat the cooktop
until it has been cleaned
thoroughly.
Clean your cooktop after each
spill. Use CERAMA BRYTE _
Ceramic Cooktop Cleaner.
Burned-On Residue
NOTE: DAMAGE to your glass surface may occur if you
use scrub pads other than those recommended.
1. Allow the cooktop to cool.
2. Spread a few drops of CERAMA BRYTE ® Ceramic
Cooktop Cleaner on the entire burned residue area.
3. Using the included CERAMA BRYTE ® Cleaning Pad
for Ceramic Cooktops, rub the residue area, applying
pressure as needed.
4. If any residue remains, repeat the steps listed above
as needed.
.
For additional protection, after all residue has been
removed, polish the entire surface with CERAMA
BRYTE ® Ceramic Cooktop Cleaner and a paper towel.
Use a CERAMA BRYTE _ Cleaning
Pad for Ceramic Cooktops.
Heavy, Burned-On Residue
1. Allow the cooktop to cool.
2. Use a single-edge razor blade scraper at approximately
a 45 ° angle against the glass surface and scrape the
soil. it will be necessary to apply pressure to the razor
scraper in order to remove the residue.
3. After scraping with the razor scraper, spread a few drops
of CERAMA BRYTE ® Ceramic Cooktop Cleaner on the
entire burned residue area. Use the CERAMA BRYTE ®
Cleaning Pad to remove any remaining residue.
4. For additional protection, after all residue has been
removed, polish the entire surface with CERAMA
BRYTE ® Ceramic Cooktop Cleaner and a paper towel.
The CERAMA BRYTE_ Ceramic Cooktop Scraper and all
recommended supplies are available through our Parts Center,
See instructions under "Assistance / Accessories" section,
NOTE: Do not use a dull or nicked blade,
Metal Marks and Scratches
.
Be careful not to slide pots and pans across your
cooktop. It will leave metal markings on the cooktop
surface.
These marks are removable using the CERAMA
BRYTE ® Ceramic Cooktop Cleaner with the CERAMA
BRYTE ® Cleaning Pad for Ceramic Cooktops.
2. If pots with a thin overlay of aluminum or copper
are allowed to boil dry, the overlay may leave black
discoloration on the cooktop.
This should be removed immediately before heating
again or the discoloration may be permanent.
NOTE: Carefully check the bottom of pans for roughness
that would scratch the cooktop.
Cb
Z
C)
Z
n
Z
©
i m
Cb
q:)
£D
LCb
:2T
©
C)
£D
O0
O0
Cb
O
O
r--l-
O
R:P