Trigger Mode - Symbol DS3578 User Manual

5 - 12 DS3578 With FIPS Digital Scanner Product Reference Guide

Trigger Mode

Parameter # 8Ah
Select one of the following trigger modes for the digital scanner.
•
Level (Standard)
time, the aiming dot changes to a standard laser scanning beam for a full decode session. The laser
scanning beam stays on until the
trigger is released. If the trigger is released before the timeout expires, the laser shuts off and no decode
occurs.
•
Two Stage Option 1 (DS3578-ER only)
the aiming dot changes to a standard laser scanning beam for a full decode session. The laser scanning
beam stays on for one-third of the currently configured decode timeout. If the trigger is pulled again while in a
decode session, the scanner beam returns to an aiming dot.
•
Two Stage Option 2 (DS3578-ER only)
the aiming dot turns off. Pulling the trigger twice quickly turns on the standard laser scanning beam for a full
decode session. The laser scanning beam stays on until the
occurs, or the trigger is released.
•
Auto Aim (DS3578-SR/HD/DP only)
mode. A trigger pull activates decode processing. After 5 seconds of inactivity the aiming pattern shuts off.
Then, after an additional time period where no activity occurs, the digital scanner enters low power mode to
conserve battery power, and remains in low power mode until a trigger pull. See
from Auto Aim on page 5-16
*
Level (Standard)
Two Stage Option 2
- Upon trigger pull, an aiming dot appears for a programmable duration of time. After this
Decode Session Timeout on page 5-22
- Upon trigger pull, an aiming dot appears. When the trigger is released,
- Upon trigger pull, an aiming dot appears. When the trigger is released,
- The digital scanner's aiming pattern is consistently on when in auto aim
to set this timeout value.
(00h)
(DS3578-ER only)
(0Fh)
occurs, a decode occurs, or the
Decode Session Timeout
Timeout to Low Power Mode
Two Stage Option 1
(DS3578-ER only)
(0Eh)
Auto Aim (DS3578-SR/HD/DP only)
(09h)
occurs, a decode