Oki IP-5620 Quick Reference Manual page 28

6
Raise the pressure roller up / down lever.
Note
There are three selectable positions (up, middle
and down) on the pressure roller up / down lever.
To raise (release) the pressure roller here, raise the
pressure roller up / down lever to the top position.
7
Feed the media between the pressure roller
and grit roller and advance the media until
the leading edge of the media comes out of
the front cover.
Advance the media until the leading edge of the
media comes out at a distance of 200 mm.
When the leading edge of the media comes out of
the front cover, a confirmation beep sounds.
Note
- Depending on the environment, the media may stick
to the paper guide and may be hard to advance. In
this case, advance the media while raising it from
the paper guide by holding both edges with hands.
- If the leading edge of a media is curled up or curled
down, the media may be caught in the printer or
may not be properly set. If the media is curled too
much, do not use it.
- Be careful that the leading edge of the media does
not touch the front cover. If the roll media tends to
roll, stretch it to eliminate the rolling before loading.
- Check that the media edge guard does not enter
under the media.
8
Move the media holders so that the both
edges of the media are equally distributed
on the pressure roller.
Load the media so that the media is
evenly applied to the pressure roller.
Noting the relationship b et we en the lab el
gradation (indication line) and the media width
will let you easily adjust the position next time
you will set the media.
Set so that the end surface of the
media comes within this range.
Note
- If you shift the media only, skewing will occur.
Adjust the load position by moving the media and
the media holders together.
9
Secure the positions of the right and left
media holders by turning the screws.
10
Hold the center of media with your hand and
turn back the flange to eliminate the slack.
Note
- Do not forcibly align the edge of media to the
indication line. Set the media straight with regard
to the roll.
Flange
27