Media Installation And Removal; Roll Media Installation Procedure - Oki IP-5620 Quick Reference Manual

Media installation and removal

Roll media installation procedure

1
Open the front cover and slide the media
edge guards to each end of the platen. Then,
close the front cover.
Note
- Move the media edge guards to both ends so they
cannot enter under the media.
- After completing the media replacement work, set
the media guards.
- When using media with adhesive applied to the
core at the end of the roll, this adhesive may stick to
the paper guide or the platen. In this case, always
clean up the adhesive before using the media.
If a blower unit is used, move it to a place where it
will not disturb the operation.
2
Put the left side media holder in position and
fix it temporarily by turning the screw.
3
Move the right side media holder to the right
end.
26
4
Set the roll media to the media holder fixed
on the left side.
Note
- When inserting the roll media in the media holder,
be careful not to cause the media to shift on the roll
or damage the end surface of roll media.
- Make sure that the core is securely fixed to the roll
holder by inserting it completely.
Media setting direction
<In case of roll media with
print side outside>
Print side
5
Set the roll media to the right side media
holder.
<In case of roll media with
print side inside>
Print side