Kyocera ECOSYS M2030dn/PN Servlce Manual page 59

Item No.
U203 Checking DP operation
Description
Simulates the original conveying operation separately in the DP.
Purpose
To check the DP operation.
Method
1. Press the start key.
2. Place an original in the DP if running this simulation with paper.
3. Select the speed to be operated using the cursor up/down keys.
Display
NORMAL SPEED
HIGH SPEED
4. Press the start key.
5. Select the item to be operated using the cursor up/down keys.
Display
CCD ADP (NON P)
CCD ADP
CCD RADP (NON P)
CCD RADP
6. Press the start key. The operation starts.
7. To stop continuous operation, press the stop key.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U207 Checking the operation panel keys
Description
Checks operation of the operation panel keys.
Purpose
To check operation of all the keys and LEDs on the operation panel.
Method
1. Press the start key. The screen for executing is displayed.
2. [Count0] is displayed and the left most LED on the operation panel lights.
3. As the keys lined up in the same line as the lit indicator are pressed in the order from the top
to the bottom, the figure shown on the touch panel increases in increments of 1. When all the
keys in that line are pressed and if there are any LEDs corresponding to the keys in the line
on the immediate right, the top LED in that line will light.
4. When all the keys on the operation panel have been pressed, all the LEDs light for up to 10
seconds.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Description
Description
Normal reading (600 dpi)
High-speed reading
Description
Without paper, single-sided original of CCD
(continuous operation)
With paper, single-sided original of CCD
Without paper, double-sided original of CCD
(continuous operation)
With paper, double-sided original of CCD
1-3-29
2PK/2PL/2PM/2PN-5