Table of Contents
Advertisement
In hybrid mode, PTZ links to the related PTZ information of analog channel. While in digital
channel model, PTZ links to the related PTZ information on the remote device which is
connected.
To link PTZ, you can leave for [Shortcut menu]->[PTZ control] to set preset
point, cruise between points and interval time, etc.
Delay: When alarm is over, the recording will last some seconds (10~300sec), and then stop.
Show message: Pop-up the dialog box of alarm information on the screen of the local host
computer.
Send email: It means sending an email to user when the alarm is turned on.
Set in the NetService interface and send email.
FTP upload: When it is enabled, the video and picture of the related record channel and
snapshot channel will be uploaded to an assigned position.
FTP upload needs to be set at Netservice interface.
Buzz: When alarm happens, the device will send out a buzz.
5.3.2 Video Blind
When the video image is influenced by the environment such as poor brightness or reaching
the set sensitivity parameter, the camera mask function and the linkage function are turned on.
The details are shown below.
Digital channel: It not only enables video blind function at the local side, but also enables the
remote device that is connected. When the remote device is with video blind, the local side will
start alarm recording, otherwise this function is not enabled.
Picture 5.7 PTZ Activation in Hybrid Mode
38
Hybrid Digital Video Recorder
HDVR series
Advertisement
Table of Contents
