Speedboost Function; Cook Time - Bosch nit5066uc Use And Care Manual

Speed Boost function
The SpeedBoost function can be used to heat large
amounts of water faster than by using heat level S'.
Limitation on use
This function is available on all elements, provided that
no other element in the same group is operating, (see
picture), tf this is not the case, the b and _ symbols will
flash on the selected element display; then it will
automatically set the power level _.
Group 1
Group 2
Setting SpeedBoost
1. Select an element.
2. Touch Speed Boost. The function is set.
Turning SpeedBoost off
1. Select an element on which SpeedBoost is set.
2. Touch Speed Boost. The function is deactivated.
Note: In certain circumstances, the function may be
deactivated automatically to protect the internal
electronic components of the cooktop.
Cook time
You can use the timer function to set a cook time for any
element. The element will turn off automatically once the
set time has elapsed.
• , CAUTION
o When using the timer, always keep an eye on the
cooktop and do not allow anything to boil over or
burn. Boilovers can cause smoke and foods and
oils may catch on fire if left on high temperature
settings.
o This function should not be used for long periods
of time, especially at high heat settings.
o Make sure the cooktop is turned off with the main
power switch after each use.
Setting the cook time
The cooktop must be turned on.
1. Select the desired element and power level.
2. Touch the Timer key. The • indicators light up next to
the element and min and the timer display L'?_' i s
shown in the timer display.
3. Touch the + or - key in the timer display. The basic
settings are displayed:
+ key- 30 minutes
- key- 10 minutes
M m
"-_ f"m
ElementTimer KitchenTimer
• rain
Speed
Timer
Boost _
ElementTimer KitchenTimer
0 rain
-4- Speed Timer
_/i Boost
4. Touch the + or - key to set the desired time.
After a few seconds the timer will start to count down.
Once the cook time has elapsed
The element turnes off once the set cook time has
elapsed. You will hear a beep. The indicator n Laappears in
the element display and the timer display shows nn ,_, , _, for
10 seconds. The • indicator next to the element stays
on. Once you touch the Timer key, the indicators and the
beep are turned off.
Changing or cancelling cook time
Touch the Timer key until the • indicator lights up next to
the desired element. Adjust the cooking time using the +
- timer to LaLa with or keys. To cancel cook time set the ' ,_n .
the- key.
Automatic timer
With this function you may select a cook time for all
elements. Once an element is turned on, the selected
time will begin to count down. The element will
automatically turn off when the cook time has elapsed.
Instructions on activating the automatic timer are found in
the chapter "Basic settings".
Note: The cook time can be changed or cancelled for
any element:
Touch the Timer key several times until the • indicator of
the desired element lights up. Adjust the cook time with
the 4- or - key, or deactivate it by setting the the timer
value to ,_,,_,.
13