Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Command or Action
Step 20
exit
Example:
Device(config-if)# exit
Step 21
interface type number
Example:
Device(config)# interface gigabitethernet0/0/2
Step 22
service instance id ethernet [evc-name]
Example:
Device(config-if)# service instance 333 ethernet
evc1
Step 23
encapsulation encapsulation-type
Example:
Device(config-if-srv)# encapsulation dot1q 5
Step 24
bridge-domain bridge-id
Example:
Device(config-if-srv)# bridge-domain 100
Step 25
cfm mip level level
Example:
Device(config-if-srv)#cfm mip level 4
Step 26
end
Example:
Device(config-if-srv)# end
Purpose
Returns to global configuration mode.
Specifies an interface and enters interface configuration
mode.
Configures an Ethernet service instance on an interface
and enters Ethernet service configuration mode.
Sets the encapsulation method used by the interface.
Binds a service instance to a bridge domain instance.
Creates a MIP and sets the maintenance level number.
Returns to privileged EXEC mode.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
Configuring Ethernet CFM
169