Enabling Ethernet Oam - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring Ethernet OAM Interaction with CFM
Command or Action
Step 6
ethernet evc evc-id
Example:
Device(config)# ethernet evc 50
Step 7 oam protocol {cfm svlan svlan-id domain domain-name |
ldp}
Example:
Device(config-evc)# oam protocol cfm svlan 10
domain cstmr1
Step 8 exit
Example:
Device(config-evc)# exit
Step 9 Repeat Steps 3 through 8 to define other CFM domains that
you want OAM manager to monitor.
Step 10 end
Example:
Device(config)# end

Enabling Ethernet OAM

The order in which the global and interface configuration commands are issued determines the configuration.
The last command that is issued has precedence.
Perform this task to enable Ethernet OAM on a device or on an interface.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface
4. ethernet oam [max-rate oampdus | min-rate num-seconds| mode {active | passive} | timeout seconds]
5. end
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
204
Configuring Ethernet Connectivity Fault Management in a Service Provider Network
type number
Purpose
Defines an EVC and enters EVC configuration mode.
Configures the EVC OAM protocol.
Returns to global configuration mode.
—
Returns to privileged EXEC mode.