Starting The Chainsaw - ALDI 53942 User Manual

45cc Petrol Chainsaw

Starting the Chainsaw

U.
WARNING: Do not start the engine whilst the chainsaw hangs from one
hand. This is very dangerous as the chain (20) may come in contact with
your body and the starting action is not controlled (Fig U).
NOTE: This chainsaw is fitted with a double action recoil starter (11).
This means the recoil starter only needs to be pulled at a steady medium
rate and not hard vigorous pulling.
1. Fill the fuel and oil tanks respectively per previous instructions and ensure
both caps are secure. Remove the bar cover (31).
2. Lift the on/off switch (4) to the "On" position (Fig V). Make sure the front
guard / chain brake (13) is on when starting for safety by pushing it firmly
towards the nose of the chainsaw bar until a click is heard (Fig W).
3. When the machine is cold, first pull out the choke control (10) to the fully
extended position (Fig X).
Engage the throttle lock button (5) by fully
depressing the safety lever (2) and then fully
squeeze the throttle trigger (3). Press the throttle
lock button (5) and hold inward and at the same
time slowly release the throttle trigger (3). The
throttle lock button (5) will engage as the throttle
trigger (3) is slowly released and will remain
engaged when the throttle trigger (3) is released.
(Fig Y).
NOTE: Point 3 is not required if the engine is
warm or is being restarted.
4. Hold the chainsaw securely on the ground, by
placing one foot on the rear handle, one hand
securing the front handle, and using your other
hand, pull at a steady and medium rate on the
recoil starter (11) (Fig Z). Repeat (up to 15 times
for first time operation as fuel needs to be drawn
through the full fuel system).
AFTER SALES SUPPORT
1800 909 909
(toll free)
V.
ON
OFF
Starting the Chainsaw
W.
BRAKE
OFF
BRAKE
ON
Y .
Z .
e-mail: help@powertoolsupport.com
MODEL: №. 53942 • 10/2016 • YR-4503
X.
RUN
START
19