Changing The Type Of Paper - Canon iPF685 User Manual

Changing the Type of Paper

ManageRe-
mainRoll
On
Note
8
Holding it at the positions indicated, close the Roll Cover.
Note

Changing the Type of Paper

Changing the Type of Paper
Follow these steps to change the type of paper specified on the printer after you have loaded paper.
If you will continue using this type of paper later, selecting Keep Paper Type > On will save the time and effort of con-
figuring the media type setting when you load the paper again. The current media type settings before you select On
will be automatically selected at that time. (See "Using the Same Type of Paper Regularly.")
• For best printing results, the printer fine-tunes the print head height and the feed amount for each type of paper. Be
sure to select the type of paper to use correctly before printing.
Important
Because the printer fine-tunes the feed amount for each type of paper, the margins and the size of printed images
•
may vary depending on the type of paper used. If margins and the size of images are not as you expected, adjust the
paper feed amount.
(See "Adjusting the Feed Amount.")
• Rolls and sheets have different printing areas, and sheets having a larger bottom margin than rolls.
(See "Print Area.")
Changing the Type of Paper
• When you load a roll, a menu for selection of the type of paper is shown on the Display Screen. Select the type of
paper, and then press the OK button.
Note
If no barcode has been printed on the roll and you have set ManageRemainRoll to On, specify the roll length after the
type of paper. (See "Specifying the Paper Length.")
378
Downloaded from ManualsPrinter.com Manuals
Barcodes
Not printed A menu for selection of the paper type and length is automatically shown on the Display Screen.
Press ▲ or ▼ to select the type and length of paper loaded, and then press the OK button.
• For details on types of paper to select, see the Paper Reference Guide. (See "Displaying the Paper Refer-
ence Guide.")
P.365
➔
• Cut the edge of the roll after the paper is advanced if it is soiled or if there are cuts from scissors or the blade
after removing creased edges. (See "Specifying the Cutting Method for Rolls.")
P.684
➔
Printer Operation After the Paper is Fed
P.581
➔
P.380
➔
iPF685
P.388
➔
P.379
➔
User's Guide