Replacing The Battery - HP ProOne 400 G1 All-in-One Hardware Reference Manual

16. Rotate the bottom edge of the access panel down (2) and press it firmly onto the chassis until it
locks into place.
You will hear audible clicks as the latches click into place.
Figure 2-19
17. Place the computer in the upright position.
18. Reconnect the power cord and external devices.
19. Lock any security devices that were disengaged when the access panel was removed.
20. Turn on the computer. The computer automatically recognizes the additional memory when you
turn on the computer.

Replacing the battery

The battery is located on the system board on the lower right side of the fan. The battery that comes
with the computer provides power to the real-time clock. When replacing the battery, use a battery
equivalent to the battery originally installed in the computer. The computer comes with a 3-volt lithium
coin cell battery.
WARNING!
fire and burns if the battery is not handled properly. To reduce the risk of personal injury:
Do not attempt to recharge the battery.
Do not expose to temperatures higher than 60 °C (140 ºF).
Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
Replace the battery only with the HP spare designated for this product.
CAUTION:
When the battery is removed or replaced, the CMOS settings will be cleared.
Static electricity can damage the electronic components of the computer or optional equipment.
Before beginning these procedures, be sure that you are discharged of static electricity by briefly
touching a grounded metal object.
Replacing the access panel
The computer contains an internal lithium manganese dioxide battery. There is a risk of
Before replacing the battery, it is important to back up the computer CMOS settings.
Replacing the battery 23