Rollei WK 10 User Manual page 41

2. Automatic Infrared Shooting Mode
After pushing the switch to ON, the blue LED indicator will flash for
about 5 seconds and then the display will turn off; the Rollei WK 10
enters into the automatic IR shooting mode . When animals or persons
move into the PIR sensor area, the camera will immediately begin to
take photos or record videos . The camera will automatically go into
Sleep Mode after recording the images .
Note:
• The default interval time is 1 minute . During this 1 minute interval,
the camera is in Sleep Mode . It is advisable to set the interval time
according to the situation in which the camera is used .
• Before setting the camera to the automatic infrared shooting
mode, make sure that all the required settings have first been
made in TEST MODE .
• While in the automatic infrared shooting mode, press any button
under the display to activate the camera if you wish to check the
capacity of the batteries and memory card .
• When the battery capacity is low, the camera will enter the power
saving mode (please refer to SETUP chart for settings) . This will
decrease the brightness of the IR LEDs and will influence the
quality of photos and videos recorded at night .
41