Input/Output Data - Furuno FAR-2117 Installation Instruction

5. INPUT/OUTPUT DATA

Input and output data are shown in the table below.
Note: This radar accepts position data fixed by WGS-84 geodetic datum only. Set the
datum to WGS-84 on the EPFS (GPS, etc.) connected to this radar. If other type of datum is
input, the error message "DATUM" appears and the AIS feature is inoperative.
Input
Data
Heading signal
Speed signal
Navaid data
External radar
signal
Alarm ACK input
Track Control unit
Output
Radar system data
ARPA data
Remote display
signal
External LCD
monitor signal
External CRT
monitor signal
Alarm signal
Specifications
synchro or step
AD-10 format
IEC 61162-2
IEC 61162-1
IEC 61162-1
Heading, Bearing,
Trigger, Video
Contact closure
RS-422
RS-232C
IEC 61162-1
HD, BP Trigger,
Video
DVI
R, G, B, H, V
Contact closure
Contents
GC-10 required
External AD-100
Position, course,
speed, LORAN-C
TD, waypoint, route,
time, wind data,
current data, depth,
temperature, roll,
pitch, ROT
No STC control
RSD, OSD, TLL,
TTM
Same as main
display unit
Same as main
display unit
Output to alarm
system by using
photo-relay
Remarks
AD-10 and
IEC 61162 are
switched by menu
setting.
Operate as remote
display
Input from alarm
system
Option
For PC plotter
For ECDIS
2 ports
2 systems in total
Option
4 systems, Output
contents are
selected by menu.
5-1