Using Service Jig; Self-Diagnosis Function - Sony DCR-HC44E Service Manual

www.freeservicemanuals.info

1-4. USING SERVICE JIG

Connect the CPC-15 jig connector (J-6082-564-A) and I/F unit for LANC control (J-6082-521-A) to the CN1014 of VC-418 board.

1-5. SELF-DIAGNOSIS FUNCTION

1-5-1. Self-diagnosis Function
When problems occur while the unit is operating, the self-diagnosis
function starts working, and displays on the viewfinder or LCD
screen what to do. This function consists of two display; self-
diagnosis display and service mode display.
Details of the self-diagnosis functions are provided in the Instruction
manual.
Viewfinder or LCD screen
C : 3 1 : 1 1
Repaired by:
C : Corrected by customer
H : Corrected by dealer
E : Corrected by service
engineer
DCR-HC44E/HC46/HC46E_L2
VC-418 BOARD
(SIDE A)
Blinks at 3.2Hz
C 3 1 1 1
Block
Refer to "1-5-3. Self-diagnosis Code Table".
Indicates the appropriate
step to be taken.
E.g.
31 ....Reload the tape.
32 ....Turn on power again.
Published in Heiloo, Holland.
I/F unit for LANC control
8
1
CPC-15
(J-6082-564-A)
1-5-2. Self-diagnosis Display
When problems occur while the unit is operating, the counter of the
viewfinder or LCD screen shows a 4-digit display consisting of an
alphabet and numbers, which blinks at 3.2 Hz. This 5-character
display indicates the "repaired by:", "block" in which the problem
occurred, and "detailed code" of the problem.
Detailed Code
1-2
(J-6082-521-A)
1/17/16