Service Note; Power Supply During Repairs; Using Service Jig - Sony HDR-SR1 Service Manual

1-1. POWER SUPPLY DURING REPAIRS

In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4 V), the power is shut off so
that the unit cannot operate.
These following method is available to prevent this.
Method:
Use the AC power adaptor (AC-L15A).

1-2. USING SERVICE JIG

1. Connect the extension cable (J-6082-352-A) between CN4006 on the MD-133 board and CN1005 on the VC-456 board.
2. Connect the extension cable (10P, 0.5 mm) (Note) between CN4015 on the MD-133 board and CN1012 on the VC-456 board.
Note: Cut off the extension cable (18P) (J-6082-393-1) to make the extension cable of 10 pins.
HDR-SR1/SR1E_L2

1. SERVICE NOTE

Extension cable (10P)
(Note)
MD-133 board (side A)
CN4015
CN4006
Extension cable (100P)
(J-6082-352-A)
CN1005
CN1012
VC-456 board (side B)
1-1
ENGLISH JAPANESE
ENGLISH JAPANESE