Table of Contents
Advertisement
1-1. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4 V), the power is shut off so
that the unit cannot operate.
These following method is available to prevent this.
Method:
Use the AC power adaptor (AC-L200C/L200D).
1-2. PRECAUTION ON REPLACING THE VC-560 BOARD OR THE INTERNAL
MEMORY (IC8701)
When replacing the VC-560 board or the internal memory (IC8701 on the VC-560 board), start the Adjust Manual in the Adjust Station and
refer to "INTERNAL MEMORY ADJUSTMENTS".
1-3. PRECAUTION ON REPLACING THE VC-560 BOARD
DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Start the Adjust Manual in the Adjust Station and execute the "DESTINATON DATA WRITE".
RESTORE DATA
When you replace to the repairing board, get the data from the former one.
Start the Adjust Manual in the Adjust Station and perform "RESTORE DATA" to get the data.
The data getting for this model is as follows.
• USB SERIAL No.
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Start the Adjust Manual in the Adjust Station and execute the "USB SERIAL No. INPUT".
1-4. USING SERVICE JIG
Connect the extension cable 80P (J-6082-718-A) between CN1101 on the DA-045 board and CN1001 on the VC-560 board.
DA-045 board (side A)
CN1101
CN1001
VC-560 board (side B)
DCR-SX30E/SX31E/SX40/SX40E/SX41/SX41E/SX50E/SX60/SX60E_L2
1. SERVICE NOTE
1. SERVICE NOTE
Extension cable 80P
(J-6082-718-A)
1-1
ENGLISH
JAPANESE
ENGLISH
JAPANESE
Advertisement
Table of Contents
