Floor Nozzle - Kärcher SC 3 Operating Instructions Manual

Steam gun
You can use the steam gun without any ad-
ditional accessories, e.g.:
– to remove light wrinkles from hanging
clothes by steaming them at a distance
of 10 to 20 cm.
– to remove dust from plants. Here, keep
a distance of 20-40 cm.
– for moist dusting, by briefly steaming
the cloth and wiping the furniture with it.
Detail nozzle
The closer this nozzle is to the contaminat-
ed area, the higher the cleaning effect, as
the temperature and the steam are highest
at the nozzle output. Especially suited for
cleaning difficult access locations, joints,
fittings, drains, sinks, toilets, blinds and
heaters. Heavy lime scale can be drenched
in vinegar prior to steam-cleaning. Let the
vinegar penetrate for about 5 minutes.
Round brush (small)
The round brush can be installed onto the
detail nozzle as an accessory. Attached
brushes can therefore be used to remove
heavy soiling.
ATTENTION
Not suitable for cleaning sensitive surfaces.
Illustration
 Attach the round brush to the detail noz-
zle.
Power nozzle
The power nozzle can be installed onto the
detail nozzle as an accessory.
The power nozzle increases the emission
speed of the steam. Therefore, it is well-
suited for cleaning very tough dirt, blowing
out corners, grooves, etc.
Illustration
 Attach the power nozzle to the detail
nozzle according to the round brush.
Round brush (big)
The round brush can be installed onto the
detail nozzle as an accessory. This round
brush allows to clean large rounded surfac-
es (e.g. sink, shower tray, bathtub, kitchen
sink).
ATTENTION
Not suitable for cleaning sensitive surfaces.
Illustration
 Attach the round brush to the detail noz-
zle.
Hand nozzle
Illustration
 Install hand nozzle on steam gun.
Pull the cloth cover over the hand nozzle.
Especially well-suited for small washable
areas, shower stalls and mirrors.

Floor nozzle

Suited for all washable walls and floor cov-
erings, e.g. stone floors, tiles and PVC
floors. Work slowly on very dirty surfaces to
allow the steam to act on the dirt for a long-
er period of time.
Note
Detergent residue or care emulsions that
are still present on the surface to be
cleaned can lead to streaks during steam
cleaning. However, these will disappear
with repeated cleaning procedures.
Illustration
 Attach the floor cloth to the floor nozzle.
1 Place the floor nozzle on top of the floor
cloth.
Depending on model - fold bevore the
floor cloth the long way.
2 Open holding clamps.
3 Place the cloth ends into the openings.
4 Close the holding clamps.
CAUTION
Do not insert fingers between the clamps.
Parking the floor nozzle
Illustration
 During work breaks, hook the floor noz-
zle into the parking holder.
English 13