Yamaha RX-A3060 Owner's Manual page 29

Connection diagram
Refer to the following diagram and connect the speakers to the unit.
ZONE OUT/PRE OUT PRE OUT (SINGLE) (FRONT)
1
The unit
2
(rear)
ZONE 2/ ZONE 3/ (REAR)
F. PRESENCE R. PRESENCE FRONT SURROUND SUR. BACK SUBWOOFER CENTER
SPEAKERS
SURROUND SURROUND BACK R.PRESENCE CENTER
R L R L R L
EXTRA SP2
SINGLE
ZONE 2/ZONE 3/F.PRESENCE
E
1
9 3
4
T
6
Y
When using only one surround back speaker, connect it to the SINGLE jack (L side).
FRONT F. PRESENCE
R L
EXTRA SP1
L
R
ZONE 2/ZONE 3/BI-AMP
R
2
9
5
Y
7
Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and
the speaker, and the other is for the positive (+) terminal. If the wires are colored to prevent
confusion, connect the black wire to the negative and the other wire to the positive terminal.
1
Remove approximately 10 mm (3/8") of insulation from the ends of the speaker cable, and
twist the bare wires of the cable firmly together.
2
Loosen the speaker terminal.
3
Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the terminal.
4
Tighten the terminal.
3 3
F R
O N
+ (red)
T
2 2
1 1
4 4
– (black)
Using a banana plug
(U.S.A., Canada, Australia, Brazil and General models only)
1
Tighten the speaker terminal.
2
Insert a banana plug into the end of the terminal.
1 1
F R
O N
T
Banana plug
2 2
Connecting the subwoofer (with built-in amplifier)
Use an audio pin cable to connect the subwoofer.
Audio pin cable
L
29
En