Connection" Tab; Upper Section: Connecting To The Pc; Lower Section: Dect Connection - Siemens M105 Operating Instructions Manual



"Connection" tab

Upper section: connecting to the PC

Lower section: DECT connection

You can set the virtual COM port at which the local adapter is connected
in the upper section of the tab.
We recommend leaving the option
start-up deactivated (as shown). The program then checks the existing
COM ports and determines where the adapter is connected. Manual in-
terface selection is only recommended if there is more than one Gigaset
M105 Data unit connected to the PC.
As soon as the program finds an adapter or identifies the manually se-
lected interface, it sends it the configuration command via the control
lines. This action switches the adapter to configuration status. This is in-
dicated by the Status:
only be configured under these conditions. Your Gigaset M105 Data will
automatically switch the adapter back to operating status at the end of the
program.
This section indicates whether a radio connection exists and if so, to
which Remote adapter. It also indicates the quality of the connection.
A Remote adapter must be registered before it can be selected here.
A
Configuration program options
No automatic detection at program
display in the dialog box. Gigaset M105 Data can
Back
11