Answering Phone Calls - Panasonic KX-FC195AL Operating Instructions Manual

3. Telephone
To turn off key lock, press and hold {j} for more
than 2 seconds.
Note:
L The key lock is cancelled if the handset is
turned off.
3.1.2 With the base unit
{A}{B}
{DIGITAL SP-PHONE}
{REDIAL/PAUSE} {LOCATOR/HOLD}
1
Press {DIGITAL SP-PHONE}.
2
Dial the telephone number.
L When the other party answers, talk into
the microphone.
3
When finished talking, press {DIGITAL SP-
PHONE}.
To switch a call to the handset
1. Press {LOCATOR/HOLD} to put a call on
hold.
L To release the hold, press {DIGITAL SP-
PHONE}.
2. Press {C} on the handset.
Note:
L When a call is on hold:
– If you do not press a button for more than
6 minutes, a beep will sound every 30
seconds.
– If you do not press a button for more than
10 minutes, the line will be disconnected.
L You cannot put a call on hold when
handset(s) is not hung up. Press {ih}.
L You cannot switch the call from the handset
to the base unit.
L If you set the call BAR feature (page 58) or
call restriction feature (page 60), do not press
the dialling buttons in step 2.
28
L Do not switch calls to the handset when direct
call (page 58) is turned on.
To redial the last number dialled from the
base unit
Press {DIGITAL SP-PHONE}, then press
{REDIAL/PAUSE}.
Speakerphone operation
L Use the speaker in a quiet room.
L Adjust the speaker volume using {A} or {B}.

3.2 Answering phone calls

3.2.1 With the handset
{C}
{v}
Important:
L To prevent battery consumption, be sure
to press {ih} if a busy tone sounds
when/after using the handset.
1
Lift the handset and press {C} when the
unit rings.
L You can also answer a call by pressing
any dial key 0 to 9, {*}, {#}, or {INT}.
(Any key talk feature)
2
When finished talking, press {ih} or place
the handset on the base unit.
Auto talk feature (Handset)
You can answer a call by lifting the handset off
the base unit, without pressing {C}. This
feature is set to off. To activate this feature, see
page 59.
To turn the ringer off temporarily
When an external call comes in, press and hold
{v} for more than 1 second.
L This function will not work for internal calls or
when the handset is on the base unit.
{ih}
{INT}