Preparing Remote Control; Setup Menu - Pioneer DEH-X6900BT Owner's Manual

- lf the unit fails to operate properly
- When strange or incorrect messages appear on the display
1
Remove the front panel (page 4).
2
Press the RESET button with а pointed instrument longer than 8 mm.
RESET button
Remove the insulation sheet before use.
How to replace the battery
lnsert the CR2025 (3 V) battery with the plus (+) and
minus (-) poles orientated properly.
AwдRNING
• Do not ingest the battery, Chemical Burn Hazard
(Тhе remote control supplied with) This product contains а coin/button cell battery. lf the coin/
button cell battery is swallowed, it сап cause severe internal burns in just 2 hours and сап lead to
death.
Кеер new and used batteries away from children.
lf the battery compartment does not close securely, stop using the product and keep it away from
children.
lf you think batteries might have Ьееп swallowed or placed inside апу part of the body, seek
immediate medical attention.
• Do not expose the battery or remote control to excessive heat such as direct sunlight or fire.
Асдuт10N
• There is а potential danger of explosion if the battery is incorrectly replaced. When replacing the
battery, replace it with the same type.
• Do not handle or store the battery with metallic tools or objects.
• lf the battery leaks, remove the battery and wipe the remote control completely clean. Then insta 11
а new battery.
• When disposing of used batteries, please comply with governmental regulations or environmental
puЬlic institutions' rules that apply in your country/area.
• "Perchlorate Material - special handling may apply.
� lmportant
• Do not store the remote control in high temperatures or direct sunlight.
• Do not let the remote control fall onto the floor, where it may become jammed under the brake or
accelerator pedal.
When you turn the ignition switch to ON after installation, the setup menu appears in
the display.
AwдRNING
Do not use the unit in standard mode when а speaker system for network mode is connected to the
unit. Do not use the unit in network mode when а speaker system for standard mode is connected to
the unit. This may cause damage to the speakers.
1
Turn the М.С. dial to select the options, then press to confirm.
То proceed to the next menu option, you need to confirm your selection.
CLOCKSEТ
Set the clock.
М.С.
1 Turn the
The indicator moves to the minute setting automatically.
М.С.
2 Turn the
SPEAKER MODE
Switch between two operation modes: the 2-way network mode
(NETWORK) and the standard mode (STANDARD) according to
[STANDARD],
the connections you have estaЬlished. For details оп operation
[NETWORK]
modes, see page 14.
After selecting the appropriate mode, turn the
select [YES], then press to confirm.
• You cannot complete the setup menu without setting the
[SPEAKER MODE].
• Once the speaker mode is set, this setting cannot
unless the default settings of this product are restored. Restore
the default settings to change the speaker mode setting (refer
to SYSTEM RESET оп page 6).
dial to adjust the hour, then press to confirm.
dial to adjust the minute, then press to confirm.
М.С.
dial to
Ье
changed
-
m
::,
'О.
iii"
:т
5
En