Sony CDP-XE800 Service Manual page 7

4-2. ADJ MODE
The following operations are performed in the ADJ mode, which
is set by connecting the TP1 (ADJ : JW75) terminal to the Ground
and turning on the power.
• During playback, there is no problem even if the GFS is continu-
ously LOW.
• High speed search is prohibited during access.
• During playback, the gain of focus servo and spindle servo does
not decrease.
• Servo related manual operations and measurement can be
performed.
(For details of operations, refer to Table of Key Operrations in ADJ
Mode.)
4-3. CLV-S MODE
The spindle servo for playback sets into the CLV-S mode when
the TP2 (AFADJ) terminal is connected to Ground after turning on
the power.
TABLE OF BUTTON OPERATIONS IN ADJ MODE
The jitter value display mode can be set after the all-music
remaining number mode using the TIME button.
The functions of the number buttons are shown in the following
table.
FUNCTIONS OF NUMBER BUTTONS
(With the attached remote commander)
Button
1 Focus bias 8-step up
2 Middle of focus bias up/down turning point
3 Tracking servo, sled servo off
4 Auto gain initialization
5 Focus servo off
6 Focus bias 8-step down
7 Immediate readjustment of focus bias
8 Tracking servo, sled servo on
10 Auto focus bias start point
Function
— 7 —
[ MAIN BOARD ] — Component Side —
CN302
CN301
TP1
(ADJ)
JW75
JW76
IC920
TP2
(AF ADJ)