Table of Contents
Advertisement
"Fill water tank?"
message
Automatic
calibration
After moving house
Before using for the first time
Initial setup
This message appears if you set an operating mode
and the water tank is only half full.
If you think that the water in the water tank is sufficient
for the cooking procedure, you can restart the
appliance.
If not, fill the water tank to "max.", slide it back in and
start the appliance.
The boiling temperature of water depends on the air
pressure. During calibration, the appliance is set to
the pressure ratios at the place of installation. This
occurs automatically when steaming for the first time
at 100 ºC. This causes more steam to develop than
usual.
So that the appliance automatically adjusts itself to
the new location, you must reset the appliance to the
factory settings (see Section: Basic settings).
In this section you will find out,
H
How to set the clock after connecting up your
appliance
H
How to change the display language
H
How to change the water hardness range
H
How to clean your appliance before using it for
the first time
Once your appliance has been connected "Uhrzeit"
(clock) and "Sprache einstellen" (Select language)
appear in the display. Set the clock and, if required,
the display language.
13
Advertisement
Table of Contents
