Starting The Engine - Shindaiwa T282 Operator's Manual

Starting the Engine

Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, "I" for ON or START and "O" for OFF
or STOP.
WARNING!
The attachment will operate immediately when the engine starts and could result in loss of control and possible
serious injury. Keep movable parts of the attachment away from objects that could become entangled or thrown.
WARNING!
Never start the engine from the operating position.
1. Slide the ignition switch to the "I" position.
2. Press the primer bulb until fuel can be seen flowing in the transparent return tube.
3. Set the choke lever to the CLOSED position if engine is cold.
4. While holding the outer tube firmly with left hand. Use your other hand to slowly
pull the recoil starter handle until resistance is felt, then pull quickly to start the
engine.
The primer system only pushes fuel through the carburetor. Repeatedly pressing the
primer bulb will not flood the engine with fuel.
IMPORTANT!
IMPORTANT!
Slide ignition to ON
Primer Bulb
Return
Tube
Press primer bulb...
Closed
Move the choke lever to the
CLOSED position
...and pull recoil
starter handle
attachment is clear
upward
ON
Hold
the unit
firmly...
Make sure the
of obstructions!
11