Panasonic BM-ET330 Operating Instructions Manual page 21

3. When you use the built-in video surveillance camera,
connect the video cable of the video surveillance cam-
era to the BNC connector of the video input cable con-
nected to an external device (for example, a digital disk
recorder).
Video cable
Coaxial cable
from a connected device
4. Connect the cables to the Wiegand and alarm output
connectors as shown in the illustration. (Refer to p. 14
for details on each cable connection.)
5. Connect the power cable to the iris reader.
Cautions:
• Pass the cables through the cable hole and lead
them out of the rear or bottom side.
• If the cables are lead out of the bottom side, coat
the cables with cable covers, etc.
• When using 12 V DC power cable, do not mistake +
and –. The wrong cable connection may cause
problems.
• Use an external power-supply device that complies
with the safety standards. (Refer to p. 35.)
6. Fix the power cable to the iris reader with the supplied
clamping tool and clamping screw to avoid disconnec-
tion.
Cables
7. Attach the LAN cable to the LAN connector.
Attach the ferrite core
supplied to the LAN cable.
8. After installation, attach the front cover to the iris reader
by fixing the supplied tamper proof screws with the
supplied screwdriver tool.
The tamperproof screw holes are
inclined to the front side approx. 15
as you can easily fasten the screws
while the iris reader is mounted to the wall.
Notes:
• Take care not to lose the supplied tamperproof
screwdriver tool, as it is required at the time of relo-
cation and setting.
• The front panel is covered with the protection film
for preventing damage. Be sure to detach the film
after the installation process of the iris reader.
Fix the power
cable to the iris
reader with the
supplied
clamping tool and
clamping screw.
°
°
Approx. 15
Tamperproof screws x 2
21