Connection Terminal - Panasonic BM-ET330 Operating Instructions Manual

● Connection terminal
q Wiegand power (card reader)
Supplies power to a card reader.
w Wiegand GND (card reader)
This is the ground terminal for the power supply and
communication between the iris reader and a card
reader.
e Wiegand DATA0 (card reader)
A signal (DATA0) is input from a card reader to this ter-
minal.
r Wiegand DATA1 (card reader)
A signal (DATA1) is input from a card reader to this ter-
minal.
t Wiegand ACCEPT-LED (access control panel)
A signal (Wiegand ACCEPT-LED) is input to control the
ACCEPT indicator of this iris reader when Wiegand out-
put is set up.
y Wiegand power (access control panel)
The iris reader works even when nothing is connected
to this terminal.
u Wiegand GND (access control panel)
This is the ground terminal for communication between
the iris reader and an access control panel.
i Wiegand DATA0 (access control panel)
A signal (DATA0) is output from this terminal to an
access control panel.
o Wiegand DATA1 (access control panel)
A signal (DATA1) is output from this terminal to an
access control panel.
!0 Wiegand REJECT-LED (access control panel)
A signal (Wiegand REJECT-LED) is input to control the
REJECT indicator of this iris reader when Wiegand out-
put is set up.
!1 RS-485 (A) (access control panel)
A signal (RS-485 (A)) is input from or output to an
access control panel.
14
@1
Pin No.
q
w
e
r
t
y
u
i
o
!0
!2 RS-485 (B) (access control panel)
!3 RS-485 (A) (card reader)
!4 RS-485 (B) (card reader)
!5 Alarm input1 (recognition start/buzzer)
!6 Recognition result output1 (ACCEPT)
!7 Recognition result output2 (REJECT)
!8 Alarm output1 (power status)
!9 Alarm output2 (tamper detection)
@0 GND
@1 Power input terminals
!1
!2
!3
!4
!5
!6
!7
!8
!9
@0
A signal (RS-485 (B)) is input from or output to an
access control panel.
A signal (RS-485 (A)) is input from or output to a card
reader.
A signal (RS-485 (B)) is input from or output to a card
reader.
An alarm signal is input to this terminal to start recogni-
tion or activate buzzer sound.
This terminal is activated when recognition is success-
fully completed.
This terminal is activated when recognition is not suc-
cessfully completed.
This terminal is closed and low when power is supplied
from an external power-supply device to the iris reader.
The terminal is opened when the power supply is shut
down.
This terminal is activated when the iris reader enters the
"tamper detection" mode by the front/rear tamper detec-
tion switch (activated until the "tamper detection" mode
is cancelled).
This is the common terminal for the alarm output con-
nectors.
12 V DC (+12 V at the left/GND at the right) or 24 V AC