Preparation; Notification About The Installation Site - Panasonic BM-ET330 Operating Instructions Manual

■ Preparation

Prepare the following items before the installation. The necessary items and their lengths differ depending on situation.
● Preparing the Necessary Items
Item
Power cable
Coaxial cable
LAN cable
Anchor bolt
1
* Only cables without connector covers are usable.
Notes:
• When you use the alarm output and Wiegand terminals, you need optional cables suited for the connectors of external
devices. Use the UL style 1571 or equivalents, AWG 22 - 16 wire.
• When you use the RS-485 terminals, you need optional twisted pair cables (AWG 22 - 16) suited for the connectors of
external devices.
• It is recommended to use shielded twisted pair cables for the open collector output connectors (!6 - !9 ) . (GND @0 is to be
2
paired.)*
2 !6 , !9 , and @0 are Pin No. Refer to p.16.
*
● Cable Preparation
Power cable (with sealing)
25 mm {1 in.} or less

■ Notification about the Installation Site

This iris reader is limited to indoor use.
Near-infrared light (contained in sunlight, incandescent light and halogen light) are used for iris image capturing by the iris
reader. If the iris reader is installed in a place which receives this light directly, it may cause invalid iris data
enrollment/recognition, as the iris reader cannot capture iris images properly.
Keep the iris reader away from the following. Otherwise, light may affect on the iris reader.
• Outdoor places
• Direct sunlight or light reflection
• Incandescent or halogen lighting
• Places where the iris reader or the user's eyes are directly exposed to light
18
Item number/Recommended type
UL style 1015 (AWG 14-18) or
equivalents
Maximum distance: 10 m {32.8 ft.}
UL Listed NEC type CM or
CL2, RG-6/U type
Recommended distance: 20 m
{65.6 ft.} or less
UL style 1666, CSA-FT4 or equivalents
10 Base-T/100 Base-TX (Category 5)
M6
Use
Necessary when supplying power from
the external power-supply device to
the iris reader
Solder both ends of the cable with M3
screw clamp terminals.
For connection between an external
video-input device and the iris reader
Connect both ends with BNC plugs.
Necessary for communication between
the iris readers and iris server
*1
Required when installing the mounting
bracket over the wall with the unicorn
anchor