Table of Contents
Advertisement
■ Rear View
Remove the cable hole cover by loosening the screws with a Phillips screwdriver.
* Refer to the setup manual (PDF file) supplied
to the administration software.
■ Internal View
● Front View
Connection terminal
Front tamper
detection switch
* Refer to the setup manual (PDF file) supplied to the administration software.
12
Mounting hook hole (x4)
System Instruction
Cable hole
Video cable
(Video surveillance
camera output)
Cable hole
(Used if you make a hole
on the wall and pass the cables)
Rear tamper detection switch*
Cable hole cover (Used if you lay cables along a wall surface)
Remove the cable hole cover by loosing the screws
with a Phillips screwdriver.
Cable hole cover
LAN connector
Mounting screw hole
(10 Base-T/100 Base-TX)
Video surveillance camera
The lens is fixed. Do not touch.
Tamper detection buzzer
volume controller*
Setup switches*
Setup cable connector*
Advertisement
Table of Contents
