Setting The Pcb Switches - Panasonic AW-RC400E Operating Instructions Manual

Installation
(Be sure to ask your dealer to install the unit.)

$ Setting the PCB switches

The switches on the CONNECTOR PCB will need to be set in accordance with the signals to be transmitted and the equipment
to be connected to the pan/tilt head.
(The switches are set to support analogue/SDI at the factory.)
≥ Analogue/SDI support
IP/IEEE switch: IEEE
422/IP switch: 422
≥ Web card support
IP/IEEE switch: IP
422/IP switch: IP
≥ IEEE1394 card support
IP/IEEE switch: IEEE
422/IP switch: 422
IP/IEEE switch 422/IP switch
12 (E)
Indoor Pan/Tilt Head AW-PH400