Panasonic AW-HE100N Operating Instructions Manual page 11

Parts and their functions
6 Mounting bracket (installed)
7 Tally lamp
This comes on or goes off in response to the control from
the controller but only when "On" has been selected as
the tally lamp use setting.
8 G/L IN connector
This is the genlock signal input connector.
This unit supports the BBS or VBS signal as the genlock
signal.
Connect it to the G/L OUT connector on the cable
compensator (AW-RC400) or other unit.
9 VIDEO OUT connector
This is the output connector for the camera's composite
video signals. Connect it to a monitor or other such
device. Use a BNC coaxial cable as the connecting cable.
 HD/SD ANALOG OUT connector
This is the output connector for the camera's HD/SD
component video signals.
Use a D-SUB 15-pin connecting cable (VGA cable) or
D-SUB 15-pin and BNC coaxial connector conversion
cable as the connecting cable.
Use a high-quality cable.
Pin No.
1

3
4 to 15 GND
 CONTROLLER connector
This is the input connector for the control signals of the
camera unit or pan-tilt head unit.
Connect it to the [TO PAN/TILT HEAD] connector on the
controller.
 SERVICE switches
These switches are used for maintenance purposes.
Keep them all at the "OFF" position.
Signal name
Pr (In Y/C mode: C)
Y (In Y/C mode: VBS)
Pb (In Y/C mode: Y)
 IR ID SET switches
These are used to select the ID of the accessory wireless
remote control.
Switches [1] to [4] correspond to the [CAM1] to [CAM4]
buttons on the wireless remote control.
 Wireless remote control signal light-sensing
area (rear)
 RESERVE button
This reserve button is used for maintenance purposes.
It is not normally used by the user.
 AC IN socket
Connect the accessory power cable to this socket.
 Option slot
11